Elight IPL Permanent Hair Removal IPL Laser Epilator Bikini Armpit Leg Women Laser Hair Removal Skin Rejuvenation Beauty Machine
How does it work?
With Selective pyrolysis and thermal effect principle, IPL Intense Pulsed Light produces a high intensity flash of filtered light from the applicator head, which has been placed in contact with the skin. The energy from the light source is absorbed by the pigment melanin, which is the chromophore, which gives hair its color. the hair rapidly absorbs this filtered light and transfers it to the surrounding cells that in turn are converted into heat. The heating denatures the cells making them incapable of producing further hair growth.
Work mode: HR (hair removal) mode, SR (skin rejuvenation) mode
Operating handle Lamp Type: two ,one for hair removal, one for skin rejuvenation
Spectral range: broad spectrum
Spectral area: 530nm~1100nm (SR) / 650nm~1100nm (HR)
Operating head area: 4.4 cm * 1.6 cm
Energy density: 0~7J / cm2 of
Pulse number: 2 (HR) / 5 (SR)
Level range: 1~10, step 1
Power supply: AC 100V-240V, 50Hz / 60Hz in
Rated input power: 150W
Non-invasive, no surgery,
No pain, slight burning sensation in treatment
It won't affect the normal work and life after treatment
No side effects
1x Host machine & handle
1* HR Head
1* SR Head
1x Operation Guide & CD
1x Power Cable
1x Laser Resistant Glasses
1) Adjust energy level
a) Adjust energy level from low to high：Don’t adjust much for one time；
b) Test before operation：watch whether the shot is normal before treatment；
c) Deep color skin shall use low energy level；
2) Note during operation
a）Long hair can absorbs more light energy and this may hurt skin. So before hair removal, cut off the longer hair（leave hair 2~3mm long）;
b）Forehead, upper lip, chin —Skin is very thin, so use low energy level; you may feel a little pain during hair removal；
c）Make the tip fully touch skin to ensure skin absorb enough light hand heat；
d）During HR operation mode, delay between two treatments shall be 30s
How to use:
1. Clean skin；
2. Start equipment and adjust relative energy level；
3. We advise users to wear goggles；
4. HR mode：first make test on skin with no hair: if skin turns a little red and a little heat, it means the energy level you set is available, then you can remove hair；
5. SR mode：first make test on skin under jawbone: if kin turns a little red
and a little heat, it means the energy level you set is available, then you
can treat with face from the bottom up；
6. Make treatment on entire parts; During treatment watch skin’s reflection
for adjusting in time;
7. Clean treated parts after treatment；
8. Treated skin needs moisturizing and avoid sunshine
Note: If the HR/ SR head can't work normally, pls reset it.
1. press "+" , "-" button, and then press " start" button for 5~6 seconds, and then you will hear a sound like" wongwong", and after sound" di" , you can loose your fingers.
2. After 2~3 seconds sounds, and then you can restart it with HR/SR to check it again. If you still don't know how to operate, pls contact us then we can send you the video. Thanks!
If you need more HR, SR heads, pls click it to buy.